Posted by John A. on April 08, 2012 at 15:49:58 from (76.1.122.180):
Guys, Hauled home the other day a 1966 656 LP! Ser# 15886 just inside the 1966 break line. So far in my inspections of it the engine is not stuck. But the oil is as nasty black as any Dsl Tractor. Plugs 4-5-6 look ok but neglected for a long time, 1-2-3 were carboned up to the point I do not see how the tractor ran, supposedly 3 yrs ago. I am covering all based here. But operating under the premise that the valve guide seal crapped out and let excessive oil through, thus the cause for the plug electrodes totally encased in carbon and burnt oil. I suspicion that the head need reworking first! But IF the rings went bad and There Is Where the problem is......??????????? #1 How is the best way to get the sleeves out & not destroy them just in-case a couple are salvageable for another project or someone else might need one. #2 What is the ID of the bore on the block that the sleeve goes into?? If I have to have a step-plate (hockey puck with a lip) made to pull the sleeve out with. OR is there a place to buy one or just what? This is my first 263 rebuild, though I have done others but not 263 before. #3 OK!,,, Thoughts, Processes, How have You done it /or How do You do it?!!! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
