Posted by JRSutton on March 26, 2012 at 10:26:27 from (75.130.109.233):
On the IH rake I've been working on - 4 bar enclosed gear.
at the gear end of the main reel, there's the big cast "eccentric" - with an outer raceway and inner raceway.
on the inner raceway, there's the main bearing where the reel's main shaft goes through.
On that same cast part, there a small hole in center of the whole part. I BELIEVE that's where the linkage from the lifting lever mounts - on a pin or bolt through that hole.
BUT - What does the end of the screw crank (for adjusting the pitch of the teeth) mount to???
The manual is very unclear on this.
Does it mount to the same hole in the eccentric that the lift linkage attaches to?
Or am I missing a part???
I know pictures would make this a lot easier but I of course can't find my )#(*$# camera right now!!
I do have one picture of what I'm calling the inner race of the eccentric. The small hole in the middle is the one I think the lifting linkage goes to.
In the manual there's a picture that makes it look like I'm missing a part that the crew crank attaches to (#3 in image number 9 if you happen to have the same manual)
But it's very hard to make anything out in that illustration.
My parts rake is a three bar - and it's VERY different in that area.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.