Are you talking about a curved link piece about a foot long which contains both a hole and a slot? If so, that piece is called the bell crank lock strap. That piece is used for trailing implements controlled with gauge wheels like planters and rear mounted cultivators. When pinning the leveling bellcrank in the slotted position it permits limited range of side to side float to follow the ground contour as necessiated by the gauge wheels. The trailing implement when raised using this position will be somewhat off level. To keep the implement level with the tractor rear axle insert the pin through the round hole and the leveling bellcrank when using trailing implements without gauge wheels. When using the lock strap you need to remove the leveling link (the approx. 4 foot long piece that runs to the touch control unit) from the tractor. I believe all of this information should be included in an Operator's Manual on a Farmall 200 tractor but is contained in an IH Operator's Manual supplement (1004220R4) for the Super C as the fast hitch was introduced in mid-production and is not in the original manual. I would suggest you obtain an Operator's Manual for your new tractor as you will find it is invaluable in the proper use of the tractor and it's designed features. Hope all of this helps somewhat in your understanding the use of your fast hitch, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
