so far I've never sold anything I've built.. so not much of a chance of that happening. in the past 20 ys.. I've only sold 1-2 tractors as well.. and never sold an implement at all.
if I need something real , lifted on a 3pt.. I have 20 fords inthe barn, all with working 3pt.
I wanted to get my angles and measurements correct before i did any finish cutting or work.
cutting a pattern out of scrap 3/16 plate for test is cheap.. cutting it out of 3/8 or 1/2" scrap uses up real good scrap.
the rebar.. I'm not so concerned about. buddy has rebar lift links on a ford and moves 4x5 round hay bales with it.. has been doing so for about 3ys..
I've welded on lots of rebar.. made gate panels and such out of it. I heat it red then weld.. so far have not had one shatter from hardening, or break out a weld. not saying it can't happen.. just tha tthe rebar in that mockup is for sure not the weak link. the top rocker panels are for sure the weak link.. that and the conenction links..
I have clevis ends for those.. but then.. i mentioned that and not many noticed...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.