Posted by soundguy on January 21, 2012 at 13:51:12 from (107.41.13.186):
sorry it's been so long on the H pics. I had taken a few over the last few days after working on her, then left the old camera in the shop. gave up on the cell phone pics.
wife has the new camera out of town.. but found the old 3mp kodak..
no particular order of the pics.
shows me cleaning and then manhandling the wheel weights.. which I believe outweigh me significantly :) had to lever them up with some pry-bar stock and a big screwdriver to get some holes lined up.
painted them hanging on a shop crane..e tc.
one pic shows the POS regualtor I was working on... field control is shot.. cutout works though... so I wire up a tickle switch using 2 ignition resistors.. about 1.5 ohms and .35 ohms on a SPDT switch, center off.. thus I have a hi / low charge, depending upon rpm.. etc.. at low rpm I can kick to high and have a few amp charge.. at hi rpm I can kick to low and have a few amp charge.. etc. she starts and purs nice.
still dinking with the muffler. is a , ahem, stanley.. was cheap.. but works.. kinda like a pipe.. :) need a new lamp. the spare I had int he shop, the base plit when i cranked it down.
complete with spitshine and decals.
I touched up the bolt heads and nuts for the wheel weights after instalation, etc.... did I mention those suckers were heavy? when I did the C, she was small enough to back into the shop to use the floor jack on. H was a lil too big for that.. and the shop crane didn't like the dirt in front of the shop.. :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
