I'm old (sort of, 48 ), fat and out of shape, (unless you consider round as being in "shape" LOL) and I just muscle them up and install them like some others here have said, using the bolts as guide pins of sorts. One thing I do that may help you though is many times if I am tired or have been sick and thus feeling weak, I install two longer then needed bolts kept for the purpose in two opposite bolt holes, then once I get the weights onto them, I install my bolts and then remove the longer ones unless I am installing more than one set. I do it in three steps. First, I hang the weight on the axle end, then I turn the weight to align it properly with the wheel, and finally I pick up one side only so I can hang it on one of the bolts, then the other side comes next and it is finished. I am also not opposed to rolling the tractor a little bit to help align things in a more advantageous position.
This post was edited by CoopertownBob at 14:45:59 01/11/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.