Posted by rustyfarmall on January 03, 2012 at 12:20:46 from (216.248.71.224):
In Reply to: 140 carb problem posted by nnaatz on January 02, 2012 at 20:41:50:
Quoting Removed, click Modern View to see
Bob, I have never done such a thing as "coining" or tapping on a needle to seat it. The only thing I do that is not suggested in any repair manual is to spray both the needle and seat liberally with aerosol carb cleaner, blow them dry, and then MAYBE a quick shot of silicon lube on both just to prevent sticking on the initial start up.
The Viton tipped needles were developed to get a longer life from the needle and seat. The old, all steel needles would wear a groove where they contacted the seat, and naturally then they would leak. Tapping on the needle to seat it CREATES a wear groove, which is exactly what you do NOT want.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.