Posted by eric skokan on March 12, 2009 at 12:09:19 from (71.212.155.122):
In Reply to: Clutch Adjusting... posted by eric skokan on March 11, 2009 at 22:02:49:
The bottom of the fork looks like it is deflected forward a bit. I just gave it a quick look so I didn't see how much, but it is definately angled forward.
Just to make sure I have the proceedure understood before I begin, first I pull the starter to get at the upper pin. Then I drive out the upper pin. Next I pull the lower pin. (How do I get at the lower pin? and how does it come out? there is no cotter pin on it. Do I drive it out like the upper pin? Maybe I undo the linkage at the transmission and push the rod forward to get the lower pin to flop down into the hand hole? It would be great if it were attached with a cotter pin I just don't think I can drive it out b/c the angle is too much from the grease access hole...) Then I remove the fork. Replace or repair the fork. Then I return the fork. (Do I attach the upper pin first?) reattach bottom pin a the while stringing together four letter words in new, creative ways...
Are there any things to watch out for while doing it? Did I get the order right? Also, I've never ordered parts through the case IH website. Any tricks to that?
I checked the clearance for the throwout bearing and it looks to be about 1/2 inch, maybe a little more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
