Posted by hatrick on December 05, 2011 at 08:58:00 from (216.57.221.66):
I need to buy a top end kit for the MD we have been working on. The motor we are swapping into the MD came out of a TD6 and had been rebuilt. It has 4" sleeves in it that protrude above the plane of the block slightly. The local IH dealer locally says that they only show one for the standard bore. I talked with a guy at Carter and Gruenewald and he said that the IH part number is 87427495 and that the MD, SMD and 400 are all the same. He seems to know what he is talking about but it conflicts a little with what I have read here and also very specifically on online sites it lists a standard bore and 4" bore. I have not been able to find an engine part breakdown for the Super MD to see if it lists the same number as the one for the MD. I would like to get a good price but it is more important to me that I get a good quality gasket and that it is correct for the bore/sleeves that I have.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.