Posted by 400D Guy on November 26, 2011 at 14:12:31 from (69.76.146.214):
One head stud was rusted real bad inside the head, and it took me 3 hours of coaxing it off to reveal the following:
The rusted stud (bottom of picture) was the center left, which the previous owner had used to hold a power steering bracket, and never tightened it down. From my limited knowledge, that is the main problem with the head. I looked quickly at the bottom of the head, and didn't see any obvious cracks, but the surface was still dirty.
At least 3 water passages were completely clogged in the block and head, plus the one partially closed in the picture.
Question: Can I take the head in to a machine shop and expect them to be able to fit new valves, guides, seat the valves, flatten the head, etc., or do I need to go to someone that works on tractors? I'm hoping with the manual, they should be able to do it.
Also, can I just "rod out" (hanger wire?) the clogged waterways in the block.
I'm thinking of leaving the rusted stud there, because I'm afraid of breaking it off trying to remove it.
This post was edited by 400D Guy at 14:14:47 11/26/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.