Posted by sflem849 on November 20, 2011 at 20:37:07 from (69.197.84.39):
In Reply to: MD split/engine swap posted by hatrick on November 20, 2011 at 18:35:44:
The rails are not attatched to the support plate unless the tractor is bolted together so that is not an issue. (I bolted the rails to the plate rather than letting all that weight hang there while the tractor was split) The plate is bolted to the motor. I would take the clutch and flywheel off if the tractor is already split because you will have to do it anyway. Why deal with it!?! (Unless you have two clutches and are keeping with the two engines?)
Anyhow. You splitting stands are bolted to the frame rails and they will hold the front half up with or without the engine. In the process you could hook the engine up to the cherry picker to support that and then take the front mounts off. Then you are done IIRC.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.