Posted by Bob M on November 11, 2011 at 15:50:50 from (69.207.87.100):
In Reply to: super h belly pump posted by ajdeereman on November 11, 2011 at 14:38:29:
Removal is fairly straightforward:
- Remove the operating lever, and unscrew the filler pipe and (3) hydraulic outlets
- Remove the dust cover under the belly casting, then remove the pump drive shaft. (Pull the large cotter pin from either end of the shaft then slide the coupling sleeve back to disengage the shaft)
- Support the pump with a suitable saddle jack then remove the (4) 3/8" cap screws from the pump mounting flange. Now lower the pump from the belly. BE CAREFUL! The pump is top-heavy and will "flop and drop" if lowered uncontrolled!!
Alternative to the above step: Get a couple 2' lengths of 3/8" threaded rod and two nuts. Remove two of the cap screws from diagonally opposite corners of the pump flange and replace with the threaded rods and nuts. Run the nuts just snug to the pump flange. Now remove the two remaining cap screws, then lower the pump by gradually turning down the nuts on the threaded rods.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
