Posted by George Rausch on October 29, 2011 at 15:13:21 from (64.85.216.186):
For what it's worth, I think I may have fixed my wobble. [DISCLAIMER= Try this at your own risk. I worry about the steering shaft cracking.] First, I serviced the wheel bearings, cleaned and lubed them, tightened up the bearings, made them smooth as butter. Next, I finally figured that my wobble was the worm gear has too much wear and slop, where it meshes with the circle gear. I noticed the mid-teeth of the worm gear were smaller thickness than the outer teeth. I ground off 1/4" of the rear of the worm gear teeth, and built a 1/4" spacer to fit between the bearing and the front of the worm gear. Stuck her all back together; this idea shifts the worm gear 1/4" to the rear. Man, does it work great. Drove all over the place, and drove a few miles into town, gassed her up, went to the car wash, miles back home, and it drives smooth, like your car. Just a very slight steering correction ever so often, just like your car. My worry is that the worm gear shaft has been ground-down, a little, and might fatigue crack. If it does I'll let everydoby know. But MAN what a difference!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.