Posted by Leroy on October 23, 2011 at 17:28:24 from (69.88.223.179):
In Reply to: Re: lift all jack? posted by Mike1972chev on October 22, 2011 at 03:55:22:
I have used those Ford jacks for years, have I think 3 at present and the hydrolick is all that is supposed to hold them up but we all know the systems sag so in lue of that and for an easier way to adjust the height I just ysed an old car bumper jack under the cross bar that the lift arms pin to and that will raise the whole tractor with ease and you have no wories about it saging down and with the hydrolick system it is hard to get an exact height and you have to be on the tractor to operate the clutch but with the way I do it easy and you are not cralling on the tractor with the wheels off to change the height as you may just need a 1/4" different in height to get that wheel back on and with the engine that is the hard part.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.