Posted by bc on October 22, 2011 at 21:38:13 from (69.148.145.78):
Hi all, finally got the loader off my 2606 so I can start working on it. Got it cleaned up and pulled the manifold. Found the left/rear end of the exhaust manifold with a broken ear. Kind of a diagonal break that extends out a ways into the manifold. Never noticed it leaking before. Just wondering what is the best way to fix it? I will probably take it to a welder on Monday. I can probably get a pic tomorrow.
I pulled it because the intake was leaking. I found the gasket pretty much disintegrated.
I see that the box connecting the two manifolds is held by 4 long bolts. The small bolt heads are very rusty like the exhaust manifold itself. I'm wondering if I should remove them to check the butterfly valve inside? If they are likely to twist off then I won't mess with them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.