Engines stop with the pistons in one of two places on a 4 cyl, and one of 3 places on a 6. This is where the the piston enters a compression stroke but stops before it completes the task. another cylinder that didn't fire was on compression but went over tdc to power stroke (with no spark) but expanded the compression air, pushing down that piston. The points are normally closed at that engine position (midway between strokes and stopped). If the Key or ignition Switch is left on, the coil will get full voltage 100% of the time. If running the coil is "on" less than 1/2 the total time (dwell). And the air is moving around the coil when running. A coil takes about 10 minutes of this torture before getting very hot. It may be just fine, if it works and makes reliable spark, no issue. The plug wires must be in the 153624. #1 toward radiator. Set #1 at TDC by pulling #1 plug, putting your thumb over the hole, and bumping (quick on off of start position) the starter around until your thumb feels compression, then turn the crank till the pointer is on the TDC timing mark. No figure out where the rotor is pointing and reset the timing. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
