I would plumb the return line into the bottom of the reservoir, ( tee at the drain plug) that would eliminate some of the air on the return side. The reservoir should be full when all the air is bled from the system and all four cylinders are in the retracted position, this would be the "at rest" full level of the reservoir. The present reservoir MAY not have enough capacity to fill all four cylinders, this would cause the pump to suck air once it has used all the fluid present in the reservoir to lift the attachments, an auxillary reservoir ( tank) may be necessary to keep the pump supplied with enough fluid.
Since you state this is a Stage II Super, I assume it came equipped with the pump & lines plumbed from the factory. If not I would check the pump operating direction to be sure the supply (big hose) & pressure (small hose) lines are not crossed at the pump.
Do not mean to offend, ( been there done that), it's hard for me to tell from the pics but it looks like yours are plumbed correctly, so no problems there.
Try to plumb the return line from the valves from a lot lower point to the reservoir, try a more direct route, air will be trapped at the highest point you have you lines plumbed, fashion an air bleeder at the highest point of your hoses, then install a plug when you have all the air bled from the system.
You have a lot of pipe & plumbing there to get all the air out of, I beleive the reservoir is going dry before the pump can fill all the routing of valves hoses & pipe and expel the air.
This post was edited by rhtx55 at 18:28:22 10/05/11 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
