Posted by IAtractorKid on October 05, 2011 at 04:47:45 from (173.26.100.72):
Hey guys! This past summer, I got screwed on some clamshell fenders I bought off craigslist. Guy said they were straight, free of dents or bends, and free of pitting or rust through with only minor surface rust. They did not have any paint left however because they had been outside in a grass fire. Needless to say, upon getting the fenders, 6 of the 7 are dented or bent in some way and 2 of them are severly pitted along the top radius with some pinholes.
I dont have the time or skill to get them back into shape to go on my show tractors so would like to sell them. I hate to scrap them since they are originals. Every one of them would be use-able as is or fairly easily fixable. Anyway, I am prepared to take a loss on them just to get them out of my way and was wondering what a fair asking price would be????
Thanks!
P.S. - If anyone is interested, they are in central IA and my email is open. Once I get a fair price set, I will have them posted in the classifieds as well...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
