Posted by Mike1972chev on October 02, 2011 at 05:49:32 from (99.75.48.212):
In Reply to: Brake job on SM posted by lblock on October 02, 2011 at 02:05:48:
DEFINITLY,
"Janicolson",helpe me tons!!! (Just did mine)
Check the balls in the expanders,clean the grooves they ride in,If balls are rusty,replace them.(cheap)lightly grease them,LIGHTLY!!!!
Sand surfaces of expanders where pads ride against them with 200 grit,side to side,NOT in circular motion (direction the disc travel.)If expanders are grooved,worn BADLY,replace them.If they are lighly scoured,they can be surfaced.replace all expander springs,if using the old expanders!!!Make sure all surfaces the disc ride against are true in the brake covers and expanders. Replace any worn hardware/linkage inside.All is available. I would sandblast the brake hats/covers and primer inside witha good primer/acid etch primer is good.MOSTURE is the enemy here !!!
Replace pinion shaft seals while it is apart! They come apart fairly simple.
Scuff up the new brake disc a little with some course sandpaper SIDE TO SIDE,(not curcular)It will stop %200 better than it ever did!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.