Posted by 36F30 on October 01, 2011 at 15:28:30 from (71.38.169.170):
In Reply to: F 12 valve timing posted by Craig45 on October 01, 2011 at 14:22:49:
Page 33 of my 1935 F12 instruction book says to set valve clearance at .016. It says nothing about them being set hot.
To check the valve timing first set the valve clearance as above and then with number one piston at TDC rotate the engine just to the point all play is taken up in the intake valve lever. Then look on the flywheel there is an I/O mark on it and it should be within 3/8" either way of the timing mark on the bellhousing. If its not, your out of time and I would look at the front crank gear, I have found a couple that ate up the keyway and were loose enough to affect the valve timing.
This post was edited by 36F30 at 15:30:11 10/01/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.