Posted by bc on September 21, 2011 at 12:25:43 from (71.158.223.75):
Well, I've about exhausted all my wits. Plan has been to remove the hoe and loader so I can do some engine work including replacing the manifold gaskets.
For years I've fought a manifold leak where I have to use full choke to start it and so on. Also have had rusty tank issues.
I have been using it this summer and it starts and runs as usual then that bolster mount broke and punched a hole in the pan.
So I drove it over and finally removed the hoe and now it won't start. I've had the carb off twice soaking it and blowing out the passages, adjusting the float and so on. It appears to be good. I have good fuel flow. I've pulled the plugs and cleaned them. I have a spark tester from HF and I have good clean blue spark at the plugs and also going into the distributor.
What happens now is that when I first turn the starter over it is firing and almost starts for a second but that is it and it will crank over without sounding like it is firing. Either using the spark tester or laying a plug wire by the frame, I am still getting good fire and I have gas in the carb. I've tried different choke settings, different carb jet settings, and different throttle settings. I can't even make it run with starting fluid which I used to be able to do. I've pulled the bottom jet and the bowl is full of fuel and I even drain it just to check the flow and it is good and the bowl stays full.
I guess the only step I can think of now is to moving the timing around some to see if that helps. It didn't do anything to make me think that it jumped time or slipped time but who knows.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
