Posted by CNKS on September 18, 2011 at 08:53:08 from (216.144.104.128):
In Reply to: TIre size for rim posted by Dave H (MI) on September 18, 2011 at 08:05:01:
Remove the tire and measure from the inside of the lips that the bead sits on. You can safely go 1 inch wider than that measurement and the tire will fit ok. The size may be stamped on the inside of the rim, if you are lucky. Ideally the tread width should be the same as the rim width. But a 10-36/11.2-36 on a 9 inch rim will be ok. If you really have an 8 inch rim you need a 9-36/9.5-36. In modern terms 9 inch tires look a little narrow -- I have a C with the old 9-36 tires on it, will probably replace with 11.2-36, but I will need new rims. 12.4's are simply too wide for that tractor unless you are into pulling or something.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.