Posted by CNKS on September 03, 2011 at 07:44:00 from (216.144.104.128):
In Reply to: 300u clutch adjustment. posted by mike paulson on September 03, 2011 at 06:30:17:
If it has a TA and you are using Hytran, yes. If it is adjusted to spec, the linkage can be sloppy and part of the pedal "clearance" is due to the worn linkage, so you might have to change the pedal clearance slightly. Also, with the tractor running look at the release bearing through the hole underneath. Sometimes the bearing will be touching the fingers so that it spins all the time. This will cause bearing wear but should not harm the clutch plate because the fingers touch the bearing by centrifugal force rather than the clearance being too tight. You might have to adjust the clutch to compromise between slight rotation of the bearing and easy shifting. Also be sure the TA is adjusted right. I have a 460 Hi Utility with that problem that I have never gotten right.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.