Posted by Tom Fleming on August 27, 2011 at 02:43:53 from (67.20.249.95):
In Reply to: Decal question posted by Mike CA on August 26, 2011 at 18:16:03:
Mike, like others have posted, you can clear coat over top, but it will look "shiney". Most decals I have used indicate not to put anything over top of it, so not sure how the mylar vs. vinyl cut will react to the solvents in the enamel (clear coat).
I shouldn't post this, as 99% will roll their eyes. But for reasons that were valid at the time, I did a TS Varspar rattle-can repaint on a tractor. I also used mylar decals. I used that tractor this summer for shows. Got lots of compliments, and I hesitate to say, I like the patina of the slight paint "fade". in fact, I would venture that akyloid rattle can paint is probably closer to the factory paint than the high end epoxy or uerathane enamels used for auto body work.
So, in the end, it is your tractor, do as YOU want. You will never beat the durability of the auto quality paints and a clear coat. Only down side, it is SHINEY! I have seen some stunning tractors with the high quality paint jobs. Good to see you posting, and again, thanks for your service to our country!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.