Posted by ih560 on August 16, 2011 at 09:30:25 from (63.131.193.36):
In Reply to: Engine parts for A posted by d beatty on August 15, 2011 at 15:49:22:
Quoting Removed, click Modern View to see
If you truly do need a New oil pump, they are available, but well over $1000, is there really anything wrong with yours? These engines, aren't like Small block chevys, where you replace the oil pump at every rebuild because they only cost like $40. I know rebuilt cams and tappets are available and I can get them for you, but you are looking at between $450 to $500. Then Connecting rods are going to be fairly expensive too, but there is that set on ebay. Why are you replacing all these parts, this is a fairly low RPM engine, and nothing so catastrophic should have happened that wiped all this out, if it did, you would need a new block anyway. I really think you should just look into another engine, if you really need all these parts and then transfer them over to your original block if you want it to be the original block.
From what I am reading, it seems that you are used to rebuilding automotive engines, and just think that it is normal to change all these things with a rebuild on these tractors, but it is not. I have had customers like this before, and I really try to convince them not to waste so much money when it is not necessary. Cam and tappets may be a decent idea if yours are really worn but I would not replace the Oil Pump and Connecting rods, unless they really are damaged.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
