Looking at that left fender in photo number 2. If I were judging that on a scale of 1 to 10 for paint I would give it a 3. You just painted over pits and bumps and God knows what else. Sparrow poop? Here is a good place to learn prep for paint. Take thefenders to a sandblester and get them done.Check them over and weld any holes or cracks. Hammer and dolly any major dents Within 24 hours spray them with epoxy primer . Just a cover coat. Use the dark gray. Fill low spots with bondo. Fill pitted areas with bondo. Using board sander and 80 grit paper sand the bondo down til you see the dark gray.
Now 3-4 good wet coats of primer sufacer. Board sand and DA sand with 220. One more time prime and wet block sand with 360 Wipe down with prepsol, wipe down with tack rag. SHoot your color coats, letting the paint tack between coats. That fender sould look like someone just took if off a 2010 GMC Sierra. If you don't have at least 16 hours of labor in the pair you rushed the job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.