Posted by The tractor vet on August 01, 2011 at 08:07:02 from (75.19.127.83):
In Reply to: 756 wiring posted by Mr_Pat_The_Cat on August 01, 2011 at 01:56:47:
well first off i do not have a wiring diagram of the way i do it . as i never set down to draw one up . I start off by using the hot wire that use to go to the fuse holder and feed a 20 amp breaker and from there to the hot post of the head light switch . Then i use the work light wire off the head light switch to feed a 30 amp relay and get power for the relay from the hot post on the starter to another 20 amp breaker and come off it to feed the relay then from the relay to the work light system . Now if you harness is that screwed up i do not know what to tell ya as i can not see it myself. And i have no idea on what all is needed . you may need a complete new harness . Keep in mind that your tractor has a resistor wire that feeds the points and here i have no idea on where you would ever find that wire to build a new harness like factory. I just got tired of always replacing the head light switches as the switch will not stand up to four headlights and one back light for long and add a couple more lights like everybody does and the fuse can not handle it . After i found myself standing in the dark one night at 2 in the morning while plowing and trying to find the little box of spare fuses in the tool box in total darkness plus the fact that i was five miles from my truck i solves that problem by doing this .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
