Posted by farmallhal on April 30, 2011 at 07:21:20 from (76.4.171.41):
I need to remove my Farmall 240 fuel tank and having never been into the sheet metal on a Farmall 240, 340, 460 or 560 was wondering if anyone could share some right and wrong ways to remove it from the tractor. I have found with the instrument panel being what appears attached to the sheet metal above the tank that it might be a little messy with everyting hanging loose and my existing original wire harnesses are not in all that good of shape to accept much abuse. I'm thinking I just need to get all the sheet metal off the top of the tractor and tank appears to be held in with four bolts so once access is obtained shouldn't be an issue. Just looking for suggestions on how to handle all the other stuff to gain access to the tank from someone who has "been there - done that". Thanks for any suggestions and comments relative to this matter, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.