Posted by Jimb2 on April 24, 2011 at 17:45:13 from (204.237.121.150):
In Reply to: IH 574 injector pump posted by B.Evers on April 24, 2011 at 14:11:36:
Hi B, hoped you lined up the timing marks and scribed everything as you should not have removed or even loosened the 3 cap screws on the pump drive gear. All that was required was to remove the big nut on the pump drive shaft. The pump drive shaft is a tapered shaft with a woodruff key in the pump drive gear. The approved method to remove the pump drive gear from the drive shaft is a special puller tool from IH. I screw the big nut off the drive shaft, put a piece of hardwood against the end of the shaft and give it a sharp tap with a hammer. Be careful not to damage the threads on the drive shaft. Also leave one of the nuts on the pump mounting bolts screwed on a couple turns so when you tap the drive shaft the pump doesn't go flying out onto the ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.