Posted by mkirsch on March 29, 2011 at 11:44:47 from (64.80.110.74):
In Reply to: 706 TRANNY posted by Wade Kalgard on March 29, 2011 at 06:16:06:
Start by pulling up the platform. Your problem lies underneath.
Odds are pretty good that the problem is a sheared-off roll pin in the lever on top of the range cover.
You need to pound out the roll pin and replace it. If the hole is worn badly, you may want to drill it out to the next size larger and use a larger roll pin.
Find a second roll pin that fits tightly inside the first and pound it inside the first pin after you've finished installing that first pin. That will reinforce the pin and make it take another 30 years to shear off again, instead of 20.
The reason the pins break is because people try to force the tractor into gear, rather than using a little "finesse." If it doesn't slip in, they pull harder. If it still won't go, they start jamming the lever back and forth.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.