Posted by MK in Ontario on March 28, 2011 at 06:22:59 from (70.54.105.86):
I've got a new rad cap for our recently acquired C from the CIH dealer. It is a thermo-syphon system. I asked for a non-pressurized cap, but the one I got has 7 lbs stamped on it. It does fit. Searching through the pages, I understand that a non-pressure rad is of different construction than a pressurized system rad and can't withstand pressure. I also understand that if it's non-pressure, the gas cap will fit and hold on it because it will have internal tab locks on it unlike the pressure ones which are external tab as most rads are these days. The rad looks very good, so I'm sure it's not original.
My question is, can this thermo-syphon system run pressurized and/or is there a new style cap that vents and doesn't cause pressure build up, and lastly, if the system is pressurized, how much should it run and where to get the cap? I've seen different cap pressures mentioned in the posts. This site won't ship to Canada, and while most things are available through the CIH dealer, there are no longer any old time IH parts guys there that would probably know the definitive answers. MK
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.