3/4 brass compression fittings are available at a good hardware store or plumbing jobber. Can't guarantee they will handle 1500 lbs. Any hydraulic shop will have steel compression fittings or other adaptors that may work for you.
"I see a sweat on fitting from the factory" That fitting is most likely furnaced brazed. You may be able to hand braze one.
Threaded pipe fittings will not work as the OD of tube is different from pipe.
I hadn't considered cutting the supply and return pipes to the IH distributer pump which is why we're talking about fittings.
Another alternative is to look at where the rear portion of the tubular manifold from the pump goes in the IH valve bank. You might be able to drill and tap an area around the small tube inlet on the big casting and attach a small adjustable needle valve to supply the PS.
But everything considered, I would do as IH did. Get the two valves, U-tube, and plug (or the whole valve bank) and set your tractor up for PS that way. You will add value to your 300. Any other way will devalue your tractor to someone who wants originality.
Another option is to use the endplate shown below. I have no idea if this will work. Owen or Pete23 (both read the forum) would know. You will most certainly have to restrict flow out of the pressure port. I think these plates are only used on 300-350 utilities. I have the one shown if you want it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.