Not familiar with the location of the particular seal, but will assume it's the typical stamped seal casing with the rubber lips in the middle.
When they're stuck hard, I usually suggest heat and penetrants, almost like busting a stuck bolt free. Heat both, the seal and the surrounding metal. As it cools, shoot your favorite (PBBlaster . . . ) onto the seam while it's still hot but cool enough that it doesn't sizzle away. As it cools it will draw the stuff in. Might take several cycles of that -- the heating and cooling will mechanically break up any rust holding it, and the penetrant will do what it does.
As for the mechanical part of pulling . . . I dont know how much you've buggered up what you have. There's the standard tool made for pulling, kind of like a double-ended narrow hammer claw. If that isn't gonna work in your situation, the most common alternative is to drive a couple of screws into the face of the shell of the seal and use a prybar to pull from under the screwhead -- it works well but works better if you've at least applied a penetrant, and even better if you put the heat to it, as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.