sflem849 in response to your last post 2/20: "Rear end bearing noise" or something of that sort seems to be the problem. It always stalled when letting out the clutch(If I let it ride that long- I was gentle- didn"t want to push the issue till I had an idea what was going on) Gear shifting and clutch action all seemed smooth. Didn"t lock up in any two gears.We were able to push 40" into barn. Thank you for your posts. Now, here"s the long story if you want to read it-2 weeks prior, a minor "bearing clunk/knock" sound.Checked gear oil at drain plug- looked good. Finished plowing. Later,tractor warming up to plow(back blade) snow again. Took a swipe & got to where the snow was piled up. Tractor spun & stopped. Figured it was combination of cold engine, too much load and not quicker on the clutch. Everything "normal" at this point. Restart,thought that lift all was maybe a little louder to raise, shift forward to pull out, and then upon releasing clutch, a new "grinding/clunk" sound and it stalled. Restart, try all gears but 5th without any shift problem, and then it would "grind" at clutch engagement & stall. Now remember my engine was cold and I"m in a small rut, but the "ol girl should have pulled out. I was very alerted by new sound, so I quit the experiments and rolled it in. I did add warm 30w non-d. oil to the lift all before the second plowing. I rechecked the lifting after pushing into barn & it seemed to actuate louder than before..... Thank you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
