OKAY! So, I went up to the farm this evening. I installed my new one wire alternator, and put on a Napa 12v coil without resistor. I think my battery is junk, it's dated 07, and barely turned over. So I got out the hand crank, never cranked a tractor in my life. After about 4 pulls on the crank it came to life, I backed it out of the trailer. The ammeter gauge didn't move off zero, I put my multimeter to the cables and my multimeter just went haywire reading -1.xx back and forth a lot.
I let it warm up for a few minutes, throttled it up about 3/4 and the ammeter gauge almost pegged at 20, then after about 2 mins came down to about the 10 mark, and then it randomly died after about 5 minutes of running. I cranked it back up, and it idled for about 10 more minutes until it got dark and I shut it off.
My question is, for whatever reason my multi meter wouldn't read the voltage in the battery while running, but isn't the needle being between 10-20 bad? I thought with 12v it would barely move? But I don't really understand how they work, so I figured I'd ask? Next step is to get a new 12v battery. I'm going to order a new 3 position switch, and re wire the tractor as soon as it's warm out. This wiring seems kind of sketchy, redoing it I believe I can handle. I just don't have a 100% grasp on how the charging system operates, though I feel I know how everything hooks up after studying diagrams.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
