Posted by Wardner on January 17, 2011 at 18:28:58 from (4.154.249.179):
In Reply to: Message for Wardner posted by DaveinSturgis on January 17, 2011 at 14:37:23:
Dave,
You are giving me more credit than I deserve when it comes to 9 series. However, I do have a 650 and some I-9 and W-9's. The later two are parts tractors.
The PS on my 650D will retrofit the WD-9. But I think you may find it difficult to find the parts to make that happen. I have never had to work on my 650 PS so I don't know how the power source differs between the tractors except to say that you will need 650 type live power. Failing that, I suppose you could attach a PS pump to the crankshaft pulley via a driveshaft through the bolster. IH also had a kit for 600-650s that did not have the Hydra-Touch system (live hydraulic power).
The CaseIH parts site does not list the 9 series. You will have to get a 600-650 parts book or I can post some photos of the relevant pages.
Your other options include cutting the steering column and installing a Char-Lynn torque generator. Or you could go with a four port hydrostatic "hand pump" and replace the axle tie-rod with a double ended steering cylinder. Both these methods are expensive and time consuming but might be a better deal as the 650 slave cylinder parts are no longer available. You will also need to hire machine and welding work if you are not equipped.
Click below for a discussion on this same topic where I posted pictures last week.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
