I believe the highest priority is to determine if the Pressure plate is worn in the pivots for the levers and plate bosses. The fact that a lever screw is tall might be because the pivot is worn. Place the driven disk in the FW and put on the Pressure plate. Use the clutch shaft to make sure the disk is centered (carefully center the shaft as it gets tight enough to just hold the disk pinched). now take down the P Plate bolts about one turn each until tight. The clutch is now pressing on the disk, and the fingers will have no pressure on them. Firmly wiggle each lever in and out as though you were the Throwout bearing. There should be just a little play, a few thousandths at best. If more, or radically different from one to the next, you have a worn plate that will not be satisfactory in use. Carefully measure the distance to the Driven disk surface while pressing the finger toward it. They should be all the same number, (It will not be a known number as the FW and new disk, and PP are all changed from original. But the screws should all be of equal height.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.