Well, now we have a different kettle of fish, haven't we? That flare doesn't look anything like the handsome pipe thread in the parts listing.
It certainly doesn't look like it in the picture, but is that perhaps the reducer and is threaded somehow onto the elbow???
Bottom line, though, I suspect the bunged up clamp is the cause of your leak. If you can get by cleaning up the mating surfaces (but not TOO well!!) with another half a clamp, that'sd be ideal.
Don't know how original you want things, but band clamps have gotten quite fashionable on automotive exhausts. Don't know if they make them down to the size you want. Even if they do, it would take a good counterman to find you the right one without an automotive application. Idea is typical band clamp, tightened down by a t-bolt rather than the screw thread in the band of a hose clamp. Welded to the inside of the band are 2/3/4 (depending on size and application) arcs of channel which grab either side of the elbow and pipe flares and tighten down.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.