It's a tough decision to make. Well researched and installed neatly I have no problem with. Cobbling is the problem. I have seen Hs with the hood cut out and it makes me sick. And then you have to choke it to kill it?? WTF?--puts the guy's bragging in perspective :)
Tractor size, My tipping point is the H. In the case of ultra high compression 12v is ideal. Maybe for convienience sake i'd be ok with a C or Cub at 12v, but it should be done neatly and function properly.
It's best to rewire the tractor during a conversion. By the time you try to modify the original harness, you have a cobbling no matter how good you are (some letter series might be an exception due to their simplicity and where the wires terminate). Furthermore, A good looking original-appearing harness might be old and brittle and turn into garbage when you start fiddling with it anyhow (personal experience with that!). Plus you should be using a bigger wire from the higher amp alternator anyway.
The emotional aspect is huge. On one side is the modification side and on the other is the purist. Part of me wants to say that when you are talking H, M, Cub, 140 you are talking about the most common, popular tractors ever, so there is room for creativity. The other part says with that attitude, they'll all be gone and no one will know what an original ever looked like. Of course without creativity and modifications, these wonderful machines from the past turn into antiquated junk that is difficult to use from today's perspective.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
