Understood you said bolt was tight in my post to you. One to OWEN A. was just to see if there was something I didn't know about the gear retaining changes. Putting a picture of shaft. Splined end is the gear mount. Race for the needle bearing is next. Needle bearing is pictured beside the shaft. Next ball bearing at rear and splined coupling that joins shaft to the next one at rear. Snap ring in the picture holds the rear ball bearing OD from moving to the rear. center housing is machined to keep it from going forward. Shaft is machined for the rear bearing ID. That along with the coupling pined to shaft keeps the bearing in place on shaft. That ball bearing handles the forward and rearward thrust of the shaft. Shaft is free to move forward and back in the needle bearing. If for some reason shaft moves to the rear enough for the drive gear to contact the needle bearing assembly it won't do it any good. If the shaft indeed has moved to the rear, thats why I suspect the ball bearing or retaining ring. Also may want to make sure the pto gear is not installed backwords on the shaft. Don't know if it would clear the housing though, never tried one backwards. Check that the top shaft has not moved forward. If it did though, most likley oil would be leaking out of the clutch compartment when running.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.