I am not a farmer and a seldom use my tractors for ground preparation. But when I do, I use a SMTA with the 300-400 two cylinder system. The horizontal front cylinder will control pitch as well as depth. The two-point sockets are welded to the bail.
On the other hand, all the later fast hitch sockets are pinned and can be converted to "floating" pitch by pulling a 3/4" diameter pin on each socket. This will allow the plow or harrow to seek its own natural pitch or level. There is even a storage hole in the socket when the pin is removed. After removing the pin, the socket can rotate up as much as 45 degrees although that is unlikely to ever happen when working ground. The plow or harrow will oscillate as it goes over a rock if something else like a plow bottom doesn't trip first.
Try to find the section in your manual where it describes the FH socket pins.
This post was edited by Wardner at 10:40:42 11/02/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.