Posted by D Slater on October 08, 2010 at 18:43:11 from (184.15.39.25):
In Reply to: super h-ta posted by 460anger on October 08, 2010 at 03:25:41:
Shifting forks are welded to the shift rails. 300 forks fit the 300 sliding gears, SH forks don't. 300 shift rails don't have the slots for popet balls and other in the correct location when used on a SH cover. When using A SH cover on a 300 trans. the 300 forks need to be welded to SH shift rails
in the correct location or 300 shift rails modified and slots cut in the correct location. SH center and 300 T/A housings are the same length.
Frame rails are longer on a 300. Use SH frame rails, radiator and shrould, , center steering and gas tank support, rear gas tank support and the SH sheet metal will work like it should. If using a Stage 2 SH hydraulic reservior the stage 2 SH tractors used a fuel tank with the outlet more to rear to clear the reservior.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.