Posted by tbone8 on October 01, 2010 at 21:56:15 from (24.12.85.241):
I bought a 1066 Hydro a couple months ago. The power steering was very weak. The transmission is the new style housing but the steering supply and return lines were plumbed to the old style routing. I checked the flow divider and it was in upside down and the spring was wrecked. I got a new spring and put it in correctly and the steering was a touch better. I swapped a steering safety valve out of another hydro I have and no better improvement. I have a flow rater so I put it on and the charge circuit pressure was in specs but the flow was not registering on the meter so I assume very little flow. Also, when I restricted the flow, the pressure only went up to about 700psi instead of at least 2000psi. I tried switching the return and supply hoses to the proper ports and that resulted in no power steering what so ever and very difficult to turn. I checked the servo pressure and that was also good. Hand pump is also good. Any thoughts would be much appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.