One other thing you might check is the linkage rod where it meets the bracket bolted to the head. That block and pin that has the springs on each side (the assembly lets you adjust the throttle (governor)control arm position)will sometimes gouge out a spot on the linkage rod and stick. Although from your description, it sounds like you have more than a sticky linkage.
The H governor is a pretty easy rebuild, although it can be pricey depending on what you need. The weight pins are a common problem and if you can wiggle the weighs a little on the pins as you say they need to be replaced. These are still available from your IH supplier at a reasonable price. You may find that the weights are worn as well - these are also available from the dealer, but sit down before they tell you the price. I think that the last set I bought for a friend was $125. I would also recommend that you put in new bushings and maybe the bearing as well since you have it apart. You can get these cheap at any bearing house.
I think the thing that fakes people out when they check the governor is that they detect only a little slop in the parts and think that such a small amount of movement can"t have such a big impact on the throttle response, but it sure does. If you rebuild yours, you"ll be amazed at the difference you"ll see.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.