Posted by Patrickl6080 on September 23, 2010 at 19:41:31 from (216.51.201.47):
I have a farmall h that has not ran for several years and am trying to get it going soaked carb and cleaned very good and put complete carb repair kit in got running. Starts and runs good but very poor throttle response. Looked at govenor and found binding throttle linkage fixed linkage problem and syncronized carb to govenor per tech manual trying to set high and low idle speeds per manual but very hard to get set. Seems like it either idles or wide open have to move throttle half way before tractor starts to speed up. Removed distribitor and checked for broken advance springs or stuck advance wheights noiticed dis springs are two different ones should they be this way and where can a person find new ones. Also looked at govenor brs and thrust washer all look ok and everything is free noticed when throttle at idle wheights are bolth free and I can wiggle them on pivot pins not like holes worn out just in and out a little like I belive they should but if throttle is wide open I can wiggle one wheight a little and the other one is tight dose anyone have any advice for dis or govenor Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.