Posted by Jimb2 on September 12, 2010 at 18:33:20 from (99.240.236.11):
In Reply to: 574 Throwount bearing posted by Justin Kuck on September 12, 2010 at 17:44:59:
Hi Justin, depends on several things, is there a loader on the tractor? Do you have a good work place, level floor to work on? Proper floor jacks and splitting stands and tools.On both sides of the front axle drive a block of wood between front axle and boltster to prevent front from tipping. If you are lucky it will have the long flexible hydraulic hose to the oil cooler up front and there will be enough slack to split without disconnecting oil cooler hydraulic hose. The fuel line comes off the top of the first fuel filter, the return fuel line comes apart at the firewall by the battery box. Remove large electrical from battery first, the other electrical should have a molex connector under the battery box. Then there are bolts and studs around the bell housing, there are two under the battery box. To put it back together we usually just put pressure plate and clutch disk on the shafts, push tractor almost together so that studs and bolts in bell housing are threaded and then install pressure plate bolts to flywheel thru the inspection plate at the bottom.
BE VERY CAREFUL, make sure you have proper jacks and splitting stands.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
