Posted by IH fan on August 14, 2010 at 18:43:31 from (70.249.66.76):
In Reply to: Sway bars on IHC 240 posted by mkirsch on August 14, 2010 at 09:13:19:
There is a more complicated than nessessary system for anti-sway on these... not even sure where to start explaining it. There is a cross shaft on the bottom rear of the differential case that is double hinged, with a triangular shaped plate welded to the right end. There is a hole near the right end of the shaft and a hole and slot in the plate. Then there are a pair of bars with holes that is pinned to an eye bolt in the right 3 point or Fast-hitch arm and they are then pinned to the triangular plate and end of the cross shaft. Pinned in the slot and the sway is limited, pinned in the holes and it is solid. I know this is impossible to picture, but like I said, it's complicated. A parts manual is helpful if you can find one. Must be 20-25 parts to do a simple thing.
This post was edited by IH fan at 18:45:03 08/14/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.