Posted by toro in texas on July 06, 2010 at 20:03:23 from (67.216.252.175):
In Reply to: 504 Farmall Specs? posted by 79fordblake on July 06, 2010 at 13:40:16:
Spark plug gap for the 504 with the C153 engine is .023. Service manual says use IH Hy-Tran Fluid or a mixture of IH torque amplifier additive and SAE 10W engine oil in the ratio of one quart of additive to each four gallons of engine oil. On the 504 the transmission, pto, lift system, power steering, and torque amplifier if so equiped, all run on the same fluid...and from the same reservoir, which holds about 12 gal. of fluid. To fill there is a 1/2" or so "level plug" on clutch side close to line with shifter. The fill plug is about 1-1/4" or so plug, at transmission top cover, alittle in front of shifter and also on clutch side. When the fluid comes running out of the "level hole", reservoir is full. I believe this info is correct but get a manual to help you and peace of mind. Also this forum has a lot of good info on the 504 that will help you. Good luck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.