Posted by sflem849 on June 15, 2010 at 07:13:07 from (69.197.84.192):
In Reply to: MTA Split problem posted by couv on June 14, 2010 at 19:50:12:
For those who haven't been back and forth
The tractor vet said: (quoted from post at 20:37:12 06/14/10) Good grief , Pull it back apart and remove the pressure plate and place it on the floor and use your hgeel and push one release lever down at a time and lock the lever down with a 1/4 inch nut then do the next and then the next this hold the pressure plate in the release possession . Next hang the pressure plate on the PTo input shaft then hang the clutch disc in the transmission shaft and slid it together , Then remove the inspection cover off the bottom of the bell housing and work up thru the bottom and bolt the pressure plate to the flywheel . This ain't rocket science it a flippen tractor. Oh and it really helps if the bell housing is clean or you will have grease clean up to your arm pit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
