Posted by nathon on June 11, 2010 at 10:02:26 from (216.227.55.31):
I can not seem to nail down the reason for only being able to achieve about 400 PSI on my 600D hydraulics. It appears to have good flow but I did not measure it. The tank is clean and has fresh oil. The suction line flows oil well to the pump. I opened up the pump to inspect and it is pristine inside. There is no scarring and the shaft seals looked good but I have replaced them. When I started it I bled the air from the system via the top hole on the pump. I put a bypass hose connecting the two remote couplers together and left it pump through there for a while also. I have disassembled the relief valve and the large safety spring was broken and I have replaced it with the correct spring. I blew compressed air through all the ports. The small screen and orifice are clean. It does not have power steering. Three nights shot and I still only get 400 psi. What am I missing or could the problem be in the control valve for the remote connection. I have never torn one of these apart. I am ready to learn the secret. Thanks in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.